3-864-740-03(1)
Speaker System
Operating Instructions
Mode d’emploi
Page 2
Istruzioni per l’uso
Page 16
Bedienungsanleitung
Manual de instrucciones
Seite 30
取扱説明書
Página 46
Pagina 60
74 ペ−ジ
お買い上げいただきありがとうございます。
警告
電気製品は、安全のための注意事項を守らないと、
火災や人身事故になることがあります。
この取扱説明書には、事故を防ぐための重要な注意事項と製品の取り扱いかたを示
してあります。この取扱説明書をよくお読みのうえ、製品を安全にお使いください。
お読みになったあとは、いつでも見られるところに必ず保管してください。
SS-X500A
1998 by Sony Corporation
English
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
English
Table of Contents
The SS-X500A is a two-way bass reflex speaker system
which adopts a cone-type woofer and tweeter. This speaker
system is designed for use with the PFM-500A1WU/A1WE
flat panel monitor. The metal mesh grill has been designed
to improve the quality of the sound. You can enjoy the high
quality stereo sound.
EN
English
Features ..................................................................... 3
Precautions ................................................................ 4
Parts List .................................................................... 5
Parts Identification .................................................... 6
Installing the Speakers ............................................. 7
Installing the Speakers on a Wall ......................9
Changing the Speaker Angles .........................10
Attaching the Ferrite Filters ................................... 11
Connecting to the Monitor ..................................... 12
Connecting to the Amplifier ................................... 14
Specifications .......................................................... 15
Features
3
Precautions
Operating and storage locations
Miscellaneous
Avoid operating or storing the product in the following
locations.
• Extremely hot or cold places
• In direct sunlight for long periods, or close to heating
equipment
• Damp or dusty places
• Where it is exposed to rain
• Locations subject to strong vibration
• Be careful not to spill water or other liquids on the unit or
allow combustible or metallic objects inside the body. If
used with foreign objects inside, the unit is liable to fail or
cause a fire or an electric shock.
• If the product is transported or shipped, repack it as
originally packed at the factory, or in materials equal in
quality.
• Avoid driving the speaker system continuously with an
input exceeding the maximum input power of this speaker
system.
• Before connecting, turn off the amplifier to avoid
damaging the speaker system.
• If the +/– connection is incorrect, the bass tones seem to be
missing and the position of the instruments becomes
obscure.
Care
• Clean the cabinet with a soft, dry cloth. If it is very dirty,
use a cloth dampened with a small quantity of neutral
detergent, then wipe dry.
• Avoid the use of volatile solvents such as alcohol, benzene,
and thinners. They may damage the surface finish, or
impair the operation of the shutter adaptor.
Ventilation
Do not wrap the unit in a cloth, etc., during operation. This
may cause the internal temperature to rise excessively and
the unit to malfunction.
4
In the event of any problems with the operation of the unit,
contact your Sony service representative.
Parts List
Speaker (2)
Bracket (2)
Speaker attachment screw
(black, M5×9) (6)
Speaker cord 2.5 m (2)
L
Speaker cord holder (4)
Bracket attachment screw
(gray, M4×14) (8)
R
Ferrite filter (4)
5
Parts Identification
Wall
attachment
hole
L
Speaker
attachment
holes
Angle lock
screw
Bracket
attachment
holes
Woofer
Tweeter
Woofer
Wall
attachment
holes
R
R
L
Speaker
attachment
holes
Angle lock
screw
Wall
attachment
hole
Speaker Front
6
Speaker Rear
Bracket
Installing the Speakers
L
R
L
Left Speaker
R
L
R
R
Install the right/left speakers using the brackets as follows:
Speaker
attachment
holes
Right Speaker
R
L
Brackets
R L L
The L-marks must be
aligned side by side.
1 Match the speaker attachment holes on the sp...